Lot of five (5) 1/4" T-Toggle Bolt or Flat Head Sleeve Anchor 1-3/4 2-1/2 3-1/8"

Description

Selling all anchors in lots of five (5). Select desired anchor from drop-down menu.
Lot of five (5) 1/4" x 1-3/4" T-Toggle Bolt
or
Lot of five (5) 1/4" x 2-1/2" T-Toggle Bolt
or
Lot of five (5) 1/4" x 3-1/8" Flat Head Sleeve Anchor
T-Toggle Bolt made by Crown Bolt, Inc. For 3/4" minimum hollow wall thickness. Installs with much smaller hole (3/8") than regular toggle bolts.
Install bolt or bolts through the holes of the item your mounting. Fold short side of "T" back against bolt and install through hole with washer and nut. Allow long side of "T" to drop on back side of hollow wall, then tighten nut.
With the T-Toggle bolt you can also create a 1/4"-20 stud (or studs) for mounting equipment that requires an air gap behind the equipment (eg. heat dissipation or wash-down applications).
The length of stud exposed after installation depends on the actual thickness of your wall. For a 3/4" wall the 1-3/4" long bolts will give you about 3/4" stud above the nut. Using the 2-1/2" long bolts on a 3/4" wall will leave you with about 1-1/2" of stud above the nut.
Standard Slotted Flat Head Sleeve Anchor
Made by Crown Bolt. Used to fasten items with counter-sunk holes to solid concrete, stone or masonry.
Use 1/4" masonry bit. Minimum depth of concrete, stone or masonry should be about 1-1/8".
Flat head of bolt is 1/2" diameter.